Training Workshop (D6.1)

The INTHEAT Workshop was held in Veszprem, Hungary, 26/04/2012, in synergy with CAPE Forum 2012 and with the DECADE (PIAP-GA-2008-230659) Conference.

There have been several training sessions and also several invited speakers delivered dedicated lectures to the project members and the audience.

CAPE for Waste to Energy
Professor Petr Stehlík, Institute of Process and Environmental Engineering – UPEI, Brno University of Technology, Technická 2, 616 69 Brno, Czech Republic

Compound Heat Transfer Enhancement Methods To Increase Heat Exchanger Efficiency
David J. Kukulka (*1), Rick Smith (2)
(1) State University of New York College at Buffalo, 1300 Elmwood Avenue,Buffalo, New York 14222 USA
(2) Vipertex™, 658 Ohio Street, Buffalo, NY 14203 USA

Heat transfer and stress analysis for a high temperature heat exchanger with inner and outer fins
Ting Ma, Ming Zeng, Qiu-wang Wang*
Key Laboratory of Thermo-Fluid Science and Engineering, MOE, Xi’an Jiaotong University, Xi’an, Shaanxi, 710049, China

Improving Energy Recovery in Heat Exchanger Networks with Intensified Heat Transfer
Ming Pan (1), Robin Smith (2), Igor Bulatov (1)
(1) The University of Manchester
(2) Process Integration Limited

Capital Cost Targeting of Total Site Heat Recovery
Andreja Nemet (1), Petar Sabev Varbanov (1), Petro Kapustenko (2), Anes Durgutović (3), Jiří Jaromír Klemeš (1)
(1) University of Pannonia
(2) AO “SPIVDRUZHNIST – T”
(3) OIKOS, svetovanje za razvoj, d. o. o.

The influence of plate corrugations geometry on Plate Heat Exchanger performance in specified process conditions
Olga Arsenyeva (1), Svetlana Buhkalo (2), Gennadiy Khavin (1), Leonid Tovazhnyanskyy (2), Petro Kapustenko (1)
(1) AO “SPIVDRUZHNIST – T”
(2) National Technical University “Kharkiv Polytechnic Institute”

Performance Parameters of Tubes Fitted with Inserts
Mengyan Yang (1), Barry Crittenden (1), Martin Gough (2), Peter Droegemueller (2), Tom Higley (2)
(1) University of Bath
(2) Cal Gavin Ltd

Integration of ammonia cooling cycle in buildings heating system by the use of computer modeling
A. Garev (1), S. Boldyryev (2), O. Arsenyeva (2), L. Tovazhnyanskyy (1), P. Kapustenko (2)
(1) National Technical University “Kharkiv Polytechnic Institute”
(2) AO “SPIVDRUZHNIST – T”

Comments are closed.